How to do the Speed Squats

Steps

1. This exercise is best performed inside a squat rack for safety purposes. To begin, first set the bar on a rack that best matches your height. Once the correct height is chosen and the bar is loaded, step under the bar and place the back of your shoulders (slightly below the neck) across it.
2. Hold on to the bar using both arms at each side and lift it off the rack by first pushing with your legs and at the same time straightening your torso.
3. Step away from the rack and position your legs using a shoulder width medium stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance and also maintain a straight back. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance which targets overall development; however you can choose any of the three stances discussed in the foot stances section).
4. Begin to lower the bar by bending the knees as you maintain a straight posture with the head up. Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
5. Begin to raise the bar as fast as possible without involving momentum as you exhale by pushing the floor with the heel of your foot mainly as you straighten the legs again and go back to the starting position. Note: You should perform these exercises as fast as possible but without breaking perfect form and without involving momentum.
6. Repeat for the recommended amount of repetitions.

Tracking it in OneRep

Add the speed squats to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.

Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.

Where the instructions come from

The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.