Steps
- Start by setting a bar attachment (straight or e-z) on a high pulley machine.
- Facing the bar attachment, grab it with the palms facing up (supinated grip) at shoulder width. Lower the bar by using your lats until your arms are fully extended by your sides. Tip: Elbows should be in by your sides and your feet should be shoulder width apart from each other. This is the starting position.
- Slowly elevate the bar attachment up as you inhale so it is aligned with your chest. Only the forearms should move and the elbows/upper arms should be stationary by your side at all times.
- Then begin to lower the cable bar back down to the original staring position while exhaling and contracting the triceps hard.
- Repeat for the recommended amount of repetitions.
Tracking it in OneRep
Add the reverse grip triceps pushdown to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.
Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.
Where the instructions come from
The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.