How to do the Power Partials

Steps

1. Stand up with your torso upright and a dumbbell on each hand being held at arms length. The elbows should be close to the torso.
2. The palms of the hands should be facing your torso. Your feet should be about shoulder width apart. This will be your starting position.
3. Keeping your arms straight and the torso stationary, lift the weights out to your sides until they are about shoulder level height while exhaling.
4. Feel the contraction for a second and begin to lower the weights back down to the starting position while inhaling. Tip: Keep the palms facing down with the little finger slightly higher while lifting and lowering the weights as it will concentrate the stress on your shoulders mainly.
5. Repeat for the recommended amount of repetitions.

Tracking it in OneRep

Add the power partials to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.

Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.

Where the instructions come from

The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.