Steps
- Sit on a low pulley row machine with a rope attachment.
- Grab the ends of the rope using a palms-down grip and sit with your back straight and your knees slightly bent. Tip: Keep your back almost completely vertical and your arms fully extended in front of you. This will be your starting position.
- While keeping your torso stationary, lift your elbows and start bending them as you pull the rope towards your neck while exhaling. Throughout the movement your upper arms should remain parallel to the floor. Tip: Continue this motion until your hands are almost next to your ears (the forearms will not be parallel to the floor at the end of the movement as they will be angled a bit upwards) and your elbows are out away from your sides.
- After holding for a second or so at the contracted position, come back slowly to the starting position as you inhale. Tip: Again, during no part of the movement should the torso move.
- Repeat for the recommended amount of repetitions.
Tracking it in OneRep
Add the low pulley row to neck to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.
Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.
Where the instructions come from
The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.