How to do the Hack Squat

Steps

1. Place the back of your torso against the back pad of the machine and hook your shoulders under the shoulder pads provided.
2. Position your legs in the platform using a shoulder width medium stance with the toes slightly pointed out. Tip: Keep your head up at all times and also maintain the back on the pad at all times.
3. Place your arms on the side handles of the machine and disengage the safety bars (which on most designs is done by moving the side handles from a facing front position to a diagonal position).
4. Now straighten your legs without locking the knees. This will be your starting position. (Note: For the purposes of this discussion we will use the medium stance described above which targets overall development; however you can choose any of the three stances described in the foot positioning section).
5. Begin to slowly lower the unit by bending the knees as you maintain a straight posture with the head up (back on the pad at all times). Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
6. Begin to raise the unit as you exhale by pushing the floor with mainly with the heel of your foot as you straighten the legs again and go back to the starting position.
7. Repeat for the recommended amount of repetitions.

Tracking it in OneRep

Add the hack squat to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.

Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.

Where the instructions come from

The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.