Steps
- Secure your legs at the end of the decline bench and lie down with a dumbbell on each hand on top of your thighs. The palms of your hand will be facing each other.
- Once you are laying down, move the dumbbells in front of you at shoulder width. The palms of the hands should be facing each other and the arms should be perpendicular to the floor and fully extended. This will be your starting position.
- With a slight bend on your elbows in order to prevent stress at the biceps tendon, lower your arms out at both sides in a wide arc until you feel a stretch on your chest. Breathe in as you perform this portion of the movement. Tip: Keep in mind that throughout the movement, the arms should remain stationary; the movement should only occur at the shoulder joint.
- Return your arms back to the starting position as you squeeze your chest muscles and breathe out. Tip: Make sure to use the same arc of motion used to lower the weights.
- Hold for a second at the contracted position and repeat the movement for the prescribed amount of repetitions.
Tracking it in OneRep
Add the decline dumbbell flyes to a routine and your previous weight and reps sit beside every set, so the decision to add load is made by what is already on the screen rather than by memory. Exercise history and volume trends are one tap away, and logging works offline for the gyms where signal does not reach.
Because OneRep tracks food on the same timeline, a stall on this lift can be read against what you were actually eating that month — which is the difference between a programming problem and an eating one. More on that in tracking progressive overload without a spreadsheet.
Where the instructions come from
The steps above come from free-exercise-db, a public-domain exercise dataset. They are general guidance, not coaching for your body: if a movement hurts, stop and get someone qualified to look at it.